20
8.
Lock
9.
Movable magazine
10.
Fixed magazine
ASSEMBLY
The compressed air tool is supplied fully assembled. Before using the tool, connect the compressed air
supply and the required compressed air accessories. See fig. 1 for recommended accessories and order
of connection. Check that the air hose is not pressurised when you install or dismantle adapters for the
compressed air supply.
Connect the tool to the compressed air supply
1.
Check whether the tool needs to be lubricated. If necessary, add two drops of oil into the
compressed air connection, see fig. 2. If you are using a lubricator, check whether you need to top
up with oil.
2.
Turn on the compressor and set the correct pressure on the regulator for the type of fastener being
used.
3.
Connect the tool to the compressed air supply (see recommended setting).
Loading fasteners
1.
Press down the lock to release the movable magazine and pull out the magazine fully, see fig. 3.
2.
Place a set of fasteners of the right type and size in the fixed magazine (39). The magazine holds
up to 100 fasteners.
3.
Press the movable magazine forwards until it locks into place.
OPERATION
Use a sample piece to check how deep the fasteners are driven in before you start using the tool. If the
fasteners are driven in too deep or not deep enough, adjust the air pressure using the regulator.
1.
Connect the tool to the compressed air supply. Check that the air pressure is within the correct
interval (see Technical Data).
2.
Load fasteners as instructed above in the ‘Loading fasteners’ section.
3.
Hold the housing and press the drive control against the work surface. Check that the tool is
straight and then gently squeeze the trigger to fire a fastener.
4.
Lift the tool from the work surface.
5.
There are two ways of using the tool:
-
Place the nose on the work surface, then gently exert pressure until the safety mechanism is
pressed down. Then squeeze the trigger to fire a fastener.
-
Squeeze the trigger and then press in the safety mechanism several times to fire several
fasteners. The tool fires a fastener every time the safety mechanism is pressed.
Summary of Contents for 071031
Page 23: ......
