− 61 −
Ths sewng machne has the ntal value to perform the optmum sewng for the sewng shapes (30 shapes).
/
Refer to
. INITIAL VALUE DATA FOR EACH SHAPE TABLE" p.98
When creatng sewng data newly, t s convenent to create t by copyng the ntal value pattern.
2-5. Using the initial value pattern
2
!0
7
!2
!1
A
B
1
2
C
1
D
1
Set the mode to the input mode.
When the back-lght of LCD dsplay
1
shows
nput mode n blue color, t s possble to change
the pattern. When the back-lght shows the
sewng mode n green color, Press READY key
2
to change over to the nput mode.
2
Call initial value pattern.
Press PATTERN NO. key
7
, and pattern
selecton screen
A
s dsplayed.
Pattern No.
B
whch s selected at present
flashes on and off on the display. Press ITEM
SELECTION key
!0
to select ntal
value pattern
.
3
Select shape.
Press SHAPE key
!2
, and shape selec-
ton screen
C
s dsplayed. Shape
D
whch
is selected at present flashes on and off on
the dsplay. Select shape D to sew wth DATA
CHANGE key
!1
. It s possble to
select the shape from among 12 shapes at the
tme of your purchase. However, t s possble
to select the shape from among maxmum 30
shapes by ncreasng the shape selecton level
(K04).
4
Perform trial sewing.
Press READY key
2
to set the mode to
the sewng mode (back-lght of LCD dsplay
1
s green). Then t s possble to perform sewng
and the selected shape can be sewn.
* Intal value pattern can edt the needle thread
tenson data only. However, t returns to the n-
tal value when changng the shape or perform-
ng re-call of the pattern. So, be careful.
5
Copy initial value pattern.
Copy the pattern whch has been selected and
confirmed through the steps above to the nor
-
mal pattern and use t.
