juju Complete 360, User Manual

Page: 15 / 61

E1. Adjust the angle to R-gear, rotate the chair to reverse, and install the ISOFIX
system .
E2. Refer to the picture to find the anchor point on the car, press the release
button on the T op T ether, and stretch the top tether to a sufficient length to hang
the top tether anchorage on the rear vehicle seat.
Note :
The top tether hook anchorage is typically permanently attached to the luggage or to
the vehicle floor.
E3. Hang on the top tether hook, tighten the top tether until the lock is displayed
in green.
E4. And shake the safety chair to check if it is secure.
Group 0+ Reverse installation complete
The 0 + group has 3 installation stress points when using the ISOFI X
and the T op T ether, please do not miss it!
Group 1 Installation method
F1. Rotate the seat to the forward direction and adjust the seat angle to 1st gear
and install the ISOFIX system .
F2. According to the child's weight, judge whether to remove the inner cushion or
not
F3. Pull out the
three-point car seat belt to the maximum length.
F4. Insert the shoulder belt under the headrest and under the child's harnesses.
Take the belt from behind the cover and pass it in front.
F5. Fasten the car belt to the buckle until you hear the "click" sound and the
buckle is locked.
F6. Press the chair with one hand and tighten the safety belt with the other hand.
Shake the safety chair to check if it is firm .
F7. Group I Forward installation complete
When your child is less than 15 kg, please install the baby's cushion on the
child's safety chair. The seat cushion is designed to ensure the comfort of a
child with very small weight and to provide the necessary protection of
the child.
Before each use of the safety chair, make sure that the it is firmly installed
and that the car seat belt is not twisted.
Page 15