JUDO JRSF
5
Intended Use
The filter may only be operated in accord-
ance with the manufacturer’s specifications.
Any other operation or operation beyond the
specified use, is not in accordance with the
manufacturer’s specifications.
Additional dangers may result in the event of
the device not being operated in accordance
with the manufacturer’s specifications and
non-observance of the danger symbols or
safety instructions. The manufacturer / sup-
plier cannot be made liable for any damages
caused by these additional dangers. The op-
erator is responsible for these risks.
The use of the device in accordance with the
customer’s specifications includes the ob-
servance of the operating instructions.
The manufacturer / supplier should be con-
sulted prior to any operation of the filter oth-
er than in the operational areas stated in
these operating instructions.
The filter may only be operated in a techni-
cally faultless condition, in accordance with
the manufacturer’s specifications and the
stated safety and danger relevant instruc-
tions and under observance of the operating
instructions!
Any functional defects are to be removed
immediately!
2.1
Water Pressure
The water pressure should be between 1.5
bar and 10 bar.
The water pressure must not exceed 1.5 bar
as otherwise the backwashing can be im-
paired! If the filter is not backwashed regu-
larly a pressure loss can result and this can
impair the filter function.
ATTENTION
(see chapter “Safety information and dan-
gers due to non-compliance”)
In the event of
water pressure above 10
bar
, the pressure reduction valve should be
fitted
in front
of the filter (see Fig. 1). If the
operating pressure is above 10 bar, this may
result in defects during operation.
2.2
Instructions Concerning
Specific Dangers
2.2.1 Electrical Devices / Equipment
Electrical devices / equipment that are not
splash-water proof and are situated in the di-
rect vicinity of the filter may be damaged by
water leaking from the filter caused as a re-
sult of the device not being operated in ac-
cordance with the manufacturer’s specifica-
tions.
In addition this may also result short circuits
if these electrical devices / equipment being
connected to the electrical power supply. In
the event of such cases persons are at risk
and may sustain electrical shocks. There-
fore any electrical devices / equipment situ-
ated in the direct vicinity should be splash-
water proof, respectively comply with the
statutory requirements for wet areas (IP44).
Fig. 1:
Pressure reducer upstream of the unit
The installation of a pressure re-
duction valve is recommended for
water pressures between 5 bar
and 10 bar
.
Electrical wiring and devices may
not be situated under or in the di-
rect vicinity of the filter!
1
1 = Pressure reducer