JUDO JRSF
11
Operation
5.4
Modifications / changes /
spare parts
ATTENTION
(see chapter “Safety information and dan-
gers due to non-compliance”)
Only original spare parts are to be used!
Independent modifications and changes are
prohibited for safety reasons! These can im-
pair the function of the filter, lead to lead and
in extreme cases can cause the filter to
burst.
The test marks imprinted on the unit are only
valid if original spare parts are used.
5.4.1 Servicing / Repair
Before carrying out any work on the filter,
which extends beyond pure operational con-
trol, the filter must be depressurised! Failure
to observe this can lead to an uncontrolled
escape of water and therefore lead to water
damage in the building. Strictly comply with
the instructions given in the “Installation”
and “Maintenance” chapters.
5.5
Stoppages
ATTENTION
(see chapter “Safety information and dan-
gers due to non-compliance”)
If a filter has to be removed from the flange
or unscrewed, the chapter "Intended use"
must always be observed!
–
Protect the flange surfaces from dam-
age! Damaged flanged surfaces cannot
close tight. As a result, escaping water
can damage the building and installa-
tions.
–
Ensure that no dirt can get into the filter!
This dirt can get into contact with and be
discharged into the drinking water when
the filter is switched back on. The health
of people who drink dirty water is at risk.
–
Store the filter in frost-free conditions!
Frost can cause any water contained in
the filter voids to freeze and thus cause
mechanical damage to the filter so that it
leaks at operating pressure or can burst.
Leaking water can cause major damage
to the building. In addition, people near
the filter can be injured by breaking off fil-
ter parts.
–
When restarting the filter, follow the in-
structions for a new filter.