JST
CMK-R INDUSTRY STANDARD APPLICATOR
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Applicators and Die sets\TS142-01
CMK-R Manual.doc
8
6. SHEAR BLADE
6-1 POSITIONING OF THE SHEAR BLADE
The Die block is correctly located when the Shear blade passes through the 2 Shear
blade anvils freely without touching either side. To set this position correctly, follow
the procedure below.
Remove the applicator from the Press and loosen the 4 x 5mm hexagon screws that
attach the Die block to the Die Plate.
Bring the Ram down slowly to align the Shear Blade, with the slot in the Shear blade
Anvil. When the Shear blade passes through the slot in the Shear blade anvil freely,
carefully re-tighten the screws.
To ensure that you have set this part correctly you can mark both sides of the Shear
blade with a pen, then slowly move the Ram up and down. If the Shear blade is
positioned correctly the ink will still be present on the Blade, if the ink has been
removed this indicates that the setting is incorrect.
Shear Blade Anvil A
Shear Blade Anvil B
Insulation Anvil
Conductor Anvil
Shear Blade
Die Plate
Die Block
