JST
CMK-R INDUSTRY STANDARD APPLICATOR
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Applicators and Die sets\TS142-01
CMK-R Manual.doc
22
Precautions:
(1) Turn off the crimping machine whenever the Press is not in use.
(2) Turn off the machine at the mains before adjusting the dies and feeder unit.
(3) Do not touch the dies unless the machine is switched off.
(4) Position the foot switch where it will not be operated by other people or
falling objects.
(5) Always concentrate on what you are doing.
(6) Work in a stable posture.
(7) Do not place any unnecessary objects on the die unit.
(8) To make sure that the operating conditions are correct, manually cycle the press
before going to automatic operation. After the handle is used, be sure to remove
it from the crimping machine.
(9)Always ensure that the safety guard is replaced after adjustment.
3.2 Adjusting the crimp height (CH)
After crimping, measure the crimp heights of the crimped terminal with a
micrometer (Contact JST for information on suitable tools) at the centre of the wire
barrel and at the centre of the insulation barrel.
Sectional view of the crimped terminal:
Cross Sections
