JRC JAN-701B -, Instruction Manual

Page: 399 / 564

7 Tools and Setting/Serviceman Menu 7-21
ECDIS
7.15.2 CCRP Setting
This function sets the parameter of the position of CCRP (Consistent Common Reference Point) and the
position of each sensor.
1) In the normal menu
After “Serviceman” menu is displayed by “Code Input” panel,
Select [(1) Serviceman]-[(3) Installation]-[(2) CCRP Setting…] in that order.
The [CCRP Setting] dialog box will be displayed.
2) Input an accurate value to each parameter column.
3) After inputting all the parameter, push the OK button. Then,
Information message is displayed.
4) Exit to “Navigation & Planning” and start again
.
GPS / Radar Antenna:
Input the position according
to the installed environment,
and change to ON the check
box in using the sensor.
CCRP:
Set the position of CCRP.
Set the radio button of the
item used effectively though
four places can be set.