Accessing the Throttle Curve Function
H-23
Note
: In each curve, the factory setting indicates INH
for points 1, 2, 4 and 5. These values are 16.5%,
33%, 66.5% and 83.5% respectively if no value
changes are made to any other points. If any of the
other points have been changed while these points
were inhibited, the inhibited points will also change
to plot a smooth curve.
If you want to keep this from happening, highlight each
point and press the
Rolling Selector
twice to activate
each of the points. Repeat as necessary. The values
for each of these points can then be fully adjusted by
the
Rolling Selector
. To inhibit the points, highlight
the desired point with the
Rolling Selector
, press the
Rolling Selector
to open the point, then press the clear
key (
CLR
) to inhibit.
1. Place the transmitter switch in the ON position.
2. Press the
List
key simultaneously to enter the
Function Mode.
3. Roll the
Rolling Selector
to highlight the
THRO
CURV
function, then press to access.
Note
: The letter/numbers directly to the right of
THRO CURV at the top left of the LCD displays the
current Flight mode switch position.
Use
NORM
for hover curves and 1, 2, 3, and 4 (3 and
4 optional) for stunt curves. We will concentrate on the
hovering curve during this example.
4. Move the
Rolling Selector
and highlight the desired
throttle point to be adjusted. Press the
Rolling
Selector
to open the point value, then roll the
Rolling
Selector
to increase and decrease the point value.
5. To set curves for flight mode switch position 1,
highlight
NORM
with the
Selector
, press, then
select ST-1 from the drop down box and repeat
steps 4 and 5.
6. To set curves for flight mode switch positions 2
through 5, repeat step 6 above.
7. To exit the Throttle Curve function, highlight the
LIST
with the
Selector
, and press.
[THRO CURV]◊N Point-L
Point-1
Point-2
Point-3
Point-4
Point-5
Point-H
0.0%
INH
INH
50.0%
INH
INH
100.0%
ST-1
EXP OFF
IN
5
OUT 5
L 1 2 3 4 5 H
Throttle Curve, Stunt 1
