Stick Auto/Auto Cut Setting
Hold Delay
H-21
The Stick Auto setting may be easier to think of
as an automatic Throttle cutoff point, since this is
function it performs.
This feature allows you to select the throttle stick position
in which the throttle hold function can be activated in the
Throttle Hold mode. Although the throttle Hold switch is
active, when using this feature the throttle will continue to
function until the throttle stick is moved below the desired
cut position selected by you.
To activate the Stick Auto function, highlight the Stick
Auto function with the selector, and press to access. Next,
roll the selector to increase/decrease the position of the
cutoff point.
The Hold Delay function allows the throttle servos
movement to be slowed when switching from Throttle
Hold back to a previous Flight Mode. This feature is
helpful when practicing Autos. If the autorotation attempt
is not going well, when the Throttle Hold switch is
released, the throttle will increase more slowly, eliminating
any sudden bursts of throttle which could damage the
mechanics of the model.
The adjustable range is from 1/10 of a second, up to a full
2 seconds of delay.
To activate the Hold Delay, highlight the Hold Delay
function with the selector, and press to access.
Next, roll the selector to the desired delay position, and
press the selector to store. A good starting value is
.75 (3/4) of a second.
[THRO Hold]
ACT
HOLD SW
HOLD Pos.
+14%
STICK AUTO
INH
HOLD DELAY
INH
