[DiaDENS-PC]
www.jpastar.com
amplitude. This regime produces effects opposite to those of the regime "7710". It is effective when used as a
preventive and treatment of physical and mental fatigue, for emotional stress, or depressions.
5.1.4. The MED programme
The
MED
(Minimal Effective Dose) programme will be applied for intense physical or mental work; in physical or
mental strain, in chronic fatigue syndrome, difficulties getting up in the morning, drowsiness, difficulty concentrating,
and as preventive measure in cold and flu seasons.
5.5 FOLL Regime
FOLL regime is based on the method developed by R. Foil. The Foil method is a method of electropuncture
diagnosis through electric channels for evaluation of functional condition of all internal organs of the human body. The
method is also intended for testing and selection of individual medicinal, homeopathic preparations and biologically
active additives.
Attention!
The regime is intended for evaluation of functional condition of the organs and systems
rather than diagnosings. We may discuss conditions when the function is reduced, normal or activated.
The studies with the Foil method can be performed in several ways:
1. Express-evaluation of the functional condition by the end points of the meridians (which is enough for
performing diagnostic procedures at home) (Supplement 1, Fig. 1, 2);
2. Evaluation of the functional condition by control or other points of meridians*;
3. Medicinal testing
Preparing for diagnosis
Two days prior to the diagnosis procedure, it is recommended that patient avoids tonics. On the day of the diagnosis,
two hours before the procedure, the patient should avoid taking coffee, or tea, or food. Immediately before the pro-
cedure, it is recommended for patient to sit in a comfortable position and relax for about 15 minutes.
Prior to the session, remove all devices generating high-frequency electromagnetic fields (cell telephones, pagers,
high-frequency ovens, TV-sets, irons, etc.). The patient will have to remove jewelry, glasses, and a watch. During the
examination, the patient must be seated or reclining comfortably.
Medicinal testing
The first measurement of the parameters will be performed with no medication.
Then the substance to be tested will be placed into the contour of the passive diagnostic electrode and the
measurement will be repeated for the same points.
Attention!
Do not place the samples under study into the passive electrode without packaging them first, as it is not
recommended to wash the electrode, whereas particles of the sample remaining on the electrode surface will distort
values of measurements obtained in subsequent diagnosis.
Comparing the parameters obtained, we may conclude on the fact how the substance under study affects the
state of the meridians.
If necessary, we may continue the testing a different medicine.
Analysis of the results obtained
For the express-diagnosis, the normal values are about 50-65 units. Values over 65 units indicate hyperfunction of
inflammation; whereas values below 50-30 units are specific for hypofunction of degeneration condition; values lower
than 20 units indicate atrophy or complete failure of the function.
For the express-diagnosis using the arrow drop effect, the difference between the maximal and subsequent values
must not exceed 5 units (irrespective of the measurement sign); if the difference is over 5 units (irrespective of the
measurement sign), this will indicate activation of pathological processes in the organs located at a given meridian.
For medicinal testing: if the parameters obtained for the sample under study are within the range of normal values
(or nearly normal) for a given patient, then the substance under study will produce optimal effect upon the
organism. And if the parameters differ considerably from the average value, then the substance under study will not
be recommended for this particular patient.
5.6. BIOFOLL Regime
The BIOFOLL regime is based on the method developed by R. Foil (see Section 5.5. FOLL Regime). BIOFOLL is a
modification of the R. Foil classic method; it differs by preliminary determining of testing voltage in In-Tan point.
