JP Selecta 2000381, Manual

Page: 14 / 16

INSTRUCTION MANUAL CODE 80025 REV G 01/2022 Page: 14
J
.P. SELECTA s.a.u. Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
8. Start the oven once again by switching it on (1).
9. Reset the safety thermostat by pressing the reset button (12)
and the red pilot (6) must turn off.
10. Select the working temperature with the thermostat control
knob (2) (minimum 5ºC below the desired safety temperature).
11. Now the oven is ready to work.
NOTE: The adjusting process of the safety thermostat is long.
For that reason, the safety thermostat is useful when the users
normally work at the same temperature.
OVENS WITH TIMER (option):
1. Put the switch selector (1) into the position.
2. Choose the time you want the oven to stop automatically with
knob (5). At the end of the cycle, the indicator lamp “END” (10)
will light up.
3. If you want to work to an indefinable time, put the timer selector
(1) in the “ON” position.
OVENS WITH PROGRAMMABLE TIMER (option):
1. Put the switch selector (1) into the position.
2. Set the starting up and stop time with the levers of the program-
mable timer.
3. Use the selector (13) to select whether you want it to only do
the first cycle marked by the levers (a single cycle) by pressing
to the right or to be cyclical (which will repeat the sequence until
the user stops the oven) by pressing to the left.
4. If you want to work to an indefinable time, put the timer selector
(1) in the “ON” position.
COMMENTS:
* Do not use the oven at a lower temperature than ambient because
the thermostat will not operate correctly.
5. When the temperature of the oven is stabilized, slowly turn the
safety thermostat knob (6) to the left until it clicks, the red indicator
lamp (7) lights up and the heating turns off permanently.
6. Block the temperature control knob (2) with the blockage device
(9) to avoid accidentally moving the knob.
7. Stop the oven with the switch (1). Open the door and leave it
cool with the door open until the temperature goes down 50% of
the working temperature (approx).