Joyner TROOPER-T2, Owner'S Manual

Page: 75 / 225

75
2.3.2. Use bolt to position the master and
slave gears on the air inlet camshaft,
as shown in the right figure.
Attention
In order to eliminate the radial
force, keep the camshaft in the leveled
position before dismounting it (to avoid
possible damages caused by excessive
radial forces)
2.4.
Remove bolts according the right
figure, remove camshaft bearing
cover
2.5.
Remove the spark plug
2.6.
Remove the camshaft slave gear.
2.6.1. Use the special tool as shown in the
right figure.
Clip the camshaft tightly, and turn the gear,
to keep the bite state of master and slave
gear; remove the fixing bolts of slave gear.
Attention:
Do not damage the surface of
the camshaft.
2.6.2. Don’t Use the special tool
(1). Screw bolt M6 on the camshaft slave
gear as the right figure show
(2). Rotate the gear with a screwdriver;
remove the bolt fixing slave gear
Attention:
Do not damage the surface of
the camshaft.
(3). Remove retainer for shaft with
tensionor, remove waveform washer,
driver ring and saddle flip washer.
Screw
Bolt
Fixer