Joyner TROOPER-T2, Owner'S Manual

Page: 107 / 225

107
5.3.
Assemble the crankshaft main
bearing cover, the crankshaft, shaft
bush, shaft body and thruster
according to the following
instructions.
5.3.1. The protruding thrust block on the
bush should match the groove on
the cylinder body for installation..
Attention
Use the bush made by the same
manufacturer. Outward
5.3.2. Smear lubricating oil on this side
(upper side) of the crankshaft before
installing it.
5.3.3. The side thrust chip with oil sink
should face outward (crankshaft
handle) for installation on the
cylinder body-bearing stand.
Attention
Smear lubricating oil on the side
of the oil sink.
The bush (lower) installed in bearing cover
must match thruster groove.
5.3.4. Smear lubricating oil on the friction
side opposite to the contact of the
bush lower parts. Install the parts
according to the forward induction
mark on the crankshaft bearing
cover.
5.3.5. After applying the lubricating oil,
tighten the bolts in the sequence
shown as the right figure for 2—3
cycles with the specified torque.
[Torque]
70±3.5N*m/51±2.5Ft_Lb
5.3.6.
Rotate the crankshaft after
assembling, you should rotate it with
ease, the torque should be less than
1Nm
Attention
:· The torque of crankshaft rotating
should be less than 1N.m /0.7Ft_Lb ;(The
torque is for installing the crankshaft only, not
for installing the piston connecting rod)
Thruster
Oil groove
Outwards
Direction mark
Diameter mark
Apply Oil