Joyner TROOPER-T2, Owner'S Manual

Page: 44 / 225

44
c.
Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by
moving parts will stick to the plug. Clean the iron dust from this dust plug .
d. Tighten the transmission oil outlet plug and the iron dust plug.
e. Remove the plug, fill oil (API 80(75) W-90 GL-3 Gear Oil
)
about 2.0 liters.
Differential lubrication
Oil replacement
You must change the oil in differential refer to Preventative maintenance and service log.
That will insure proper lubrication of internal parts and prevent costly repairs due to
excessive wear.
a. Put the vehicle on the level ground.
b.
Shut down the engine; put an oil container under differential oil outlet plug. Loosen
the oil outlet plug in the differential. Let the oil out fully.
c. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by moving
parts will stick to the plug. Clean the iron dust from this dust plug.
d.
Tighten the differential oil outlet plug
e. Remove the oil inlet plug; fill oil (API 80(75) W-90 GL-3 Gear Oil
)
about 0.4 liters.
f. Replace the oil inlet plug, and tighten with 30N*m torque.
g. Change the oil in front differential with the same steps.
Engine Coolant
Add Coolant
You must check the coolant for level and leaks. If it is low, you need to refill coolant into
the radiator (approximately 6000 ml). The lack of coolant will cause the engine to
overheat. This can cause engine damage.
The coolant should always be topped up, since the coolant can evaporate.
Oil inlet
Oil outlet plug