Joyner SZ250DI, Owner'S Manual

Page: 21 / 77

20
Never engage the shift lever when the Go-kart is in motion
Only engage the shift lever when the Go-kart is at a full stop
Give a slight throttle and loosen throttle, then engage shift from neutral to shift.
The shift lever must be on neutral and pull parking lever when leave the Go-kart
F
．
Parking Adjustment
a.
Press down the reverse lever to the
“F” position so that the unit can move
forwards; pull back the lever to “P” so
that the unit can park. (See Fig. 6)
Adjust Nut #1; Make sure cable is not
too tight or too loose. Adjust Nut #2
accordingly to adjustment of Nut
#1.
Figure 6
G
。
Starting And Operating Instructions
a. Before starting the engine, be sure
that the driver is seated properly in the
Go-Kart and tighten the seatbelt.
b. Testing the Go-Kart in an open
place at the beginning to learn how to
start, turn and stop.
c. Operate the Go-Kart slowly until you are familiar with it.
d. The turning radius of this Go-Kart is small and agile, so the centrifugal force
is very high when turning at high speed. Slow down to a more controllable speed
when turning to prevent the Go-Kart from rolling over.
e. To prevent vehicle from rolling over, be sure to only turn the vehicle at a slow
more controllable speed. Heel on the ramp of the main board when turning, Keep
your leg rely on the foot pedal, you can feel the kart is stable because of the
gravity is adjusted and won’t roll over.
SERVICE INSTRUCTION
A
．
Service Air Cleaner
Service air cleaner every 80 hours.
Service more often under dusty conditions.
a. Remove cleaner cover 1
b. Remove air cleaner element 2 (See Fig.
7)
c. Check the paper filter, if the filter is
dusty, please replace with a new
one.
B. Engine Lubrication
You must change the oil in the crankcase after the first 5 hours of operating of
your new engine (See Fig. 9) and after 10 hours of use thereafter. That will insure
ADJUSTING NUT
ADJUSTING NUT
Figure 6
Figure 7