Joyner SZ250DI, Owner'S Manual

Page: 17 / 77

16
PARKING WARNING
OPERATION
A ． Operation controls
WARNING-Do not attempts to start or operate the engine until completely
familiar with the location and use of each control necessary to operate this
vehicle. The operator must know how to stop this machine before starting and
driving it.
a. Throttle
The right foot pedal is the throttle that controls the Go-Kart speed. As the
engine speed increased above idle, the clutch automatically engages and moves
the vehicle forward. To disengage the clutch at any time, allow the throttle to
return to the idle position. (See Fig. 1)
Each time prior to starting the engine, check the throttle assembly to ensure that when
pedal is pushed all the way forward the assembly is working smoothly and returns to idle
when released. Do not operate if pedal or engine throttles linkage fail to return to idle. If
unable to correct the problem through lubrication, adjustment or replacement of worn parts,
contact your dealer for assistance.
b. Brake
The brake is located on the
left side of the kart (See Fig. 1).
Applying pressure to the pedal
draws the brake caliper around
the brake pump at the rear wheel
and slows or stops the kart.
Figure 1
c. Start engine
Insert the key into key-switch,
turn the key clockwise, and
release the key when the engine
starts. The engine will warm up
within 5 minutes and the engine
choke will close automatically
and operate at normal RPM
(Warning: Don’t crank starter
more than 5 seconds at one
time). (See Figure 2)
BRAKE PEDAL THROTTLE PEDAL
IGNITION START SWITCH
HORN BUTTON
LEFT
RIGHT TURN
REVERSE
NEUTRAL
FORWARD
HIGHT BEAM HEADLIGHT
DIPPED BEAM HEADLIGHT FOG LAMP