Joyner JNSZ800MV, Owner'S Manual

Page: 40 / 131

2.1.1. With the engine warm, put the vehicle on the level ground.
2.1.2. Shut down the engine, put a collecting oil plate under the engine oil outlet. Let the
engine oil out fully (see Fig. 38) .
2.1.3. Tighten the engine oil outlet plug.
2.1.4. Remove the oil filler cap
(see Fig. 36) , fill oil (SAE 10W/30-50 ) about 3.86 liters to
the engine.
2.1.5. Pull out the engine oil dip stick (see Fig. 36) , confirm the corrective oil level in the
crankcase (see Fig. 37) .
2.2. Check engine oil and recharge
2.2.1. If the color of engine oil changes, you need to replace the engine oil as above.
2.2.2. Check the engine oil level; charge from 2.1.4 as above if the oil level is lower than
“L”,
3. Transmission lubrication
3.1.Oil replacement
You must change the oil in the transmission refer to preventative maintenance log after
the first 10 hours of operating of your new engine and after 40 hours of use thereafter. That
will insure proper lubrication of internal parts and prevent costly repairs due to excessive
wear (See Fig. 39).
3.1.1. Put the vehicle on the level ground.
3.1.2. Shut down the engine, put a collecting oil plate under the transmission oil outlet.
Loosen the oil outlet plug in the transmission. Let the transmission oil out fully (see
Fig. 36
、
38).
3.1.3. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by moving
parts will stick to the plug. Clean the iron dust from this dust plug (see Fig. 38) .
3.1.4. Tighten the transmission oil outlet plug and the iron dust plug (see Fig. 38) .
3.1.5. Remove the plug (see Fig. 39), fill oil (API 80(75) W-90 GL-3/ GL-5 Gear Oil ) about
2.0 liters.
3.2. Check transmission oil
If the color of transmission oil changes, you need to replace oil. Replace transmission
oil as above.
4. Engine Coolant
4.1. Add Coolant
You must check the coolant for level and leaks. If it is low, you need to refill coolant into
the radiator (approximately 6000 ml). The lack of coolant will cause the engine to overheat.
FIGURE 39
Oil inlet
Oil outlet