put the shift lever in neutral
3.
Insert the key into the
ignition-switch
If the engine is cold;
1. Pull the choke out fully
Figure 2
2. Press down the clutch pedal
3. Turn the key clockwise to the “on” position. Release the key and the clutch
pedal when the engine starts.
4. Push the choke back slowly to allow the engine to run smoothly. Keep engine
running for 1-2 minutes.
5. Push the choke back fully. If the idle of engine is not smooth, pull out the choke
to find the best running position and keep running for a while long until the engine ryns
smooth without choke.
If the engine is warm;
Press the throttle slightly and turn the key clockwise to the “on” position, release
the key and the throttle when the engine starts.
Each time prior to starting the engine, check the throttle assembly to ensure that when
pedal is pushed all the way forward the assembly is working smoothly and returns to idle
when released. Do not operate if pedal or engine throttle linkage fail to return to idle. If
unable to correct the problem through lubrication, adjustment or replacement of worn parts,
contact your dealer for assistance.
Before you start the engine, check that the parking brake is engaged, and the gear shift
lever is in neutral. Trying to start the engine in gear may damage the starter motor, clutch or
gearbox.
Release the key at once if the engine starts. Holding the key in start position when the
engine is running will cause damage to the starter motor.
If the engine does not start after 10 seconds, a second attempt to start the engine can be
allowed. Improper operation will damage the engine.
OPERATION
e.
Engine stop key
Important-stop key test.
Before driving this vehicle, test the Engine Stop key to assure that it is operating
17
Summary of Contents for JNSZ650DL
Page 39: ...WIRING DIAGRAM 38 ...
Page 40: ...39 ...
