“LVP“
Hereby, the undervoltage protection can be
activated. With “OK“ you can change the value, if the
value is “0“, the function is deactivated. This function
shifts the relay to interrupt the circuit.
“OVP“
Hereby, the overvoltage protection can be activated.
With “OK“ you can change the value, if the value is
“0“, the function is deactivated. This function shifts
the relay to interrupt the circuit.
“CLR“
This buttons deletes all saved values of Ah, Wh and
time. Additionally, the battery status is set on 100 %.
“BAT“
You can adjust here the values of the battery with this
button.
“SET“
You can adjust here the fundamental setteings of the
device.
“ADR“
With “ADR“ the communication address can be
adjusted.
“FCH“
With “FCH“ the communication channel can be
adjusted.
“BRI“
You can adjust here the brightness of the display.
“LNG“
You can change here the language.
Important: To go to the “LNG“ option, you must enter “ADR“ and hold down
the down arrow key for 3 seconds.
7. CONNECTING SEVERAL DEVICES TO ONE DISPLAY
To connect several devices to one display, you must first assign different
addresses to the devices.
1. To do this, connect your display to your device using the USB cable.
2. Now open the menu by pressing the OK key.
3. Use the arrow keys to navigate to the ADR. menu item and press the OK key.
4. Now you can select the address with the arrow keys. By changing the
address you should now see the following symbol in the upper left corner of
the display:
5. To confirm the address, press and hold the OK button for about three
seconds.
6. If you now release the key, the display should change and the following
symbol appears:
In this way, you can assign different addresses to each device.
