12
www.jotul.no
Rear connection directly behind the fireplace
Start by measuring the distance from the floor to the
middle of the fireplace’s rear connecting piece.
Install the support leg on the rear connection, adapt
the length of the support leg so that the measurement
between the floor and the centre is the same as on the
stove. This adaptation can be performed by cutting the
leg or, in the case of a small adjustment, screwing the
nut on the foot.
The length of the cladding pipe must be adapted to the
existing installation.
Start by removing the ring from the bottom of the rear
connection.
Place the cladding pipe to the side of the rear connection
with the rubber ring end at the top. Cut the cladding pipe
so that it just reaches the bottom of the rear connection.
Turn the cladding pipe so that the cut side is facing the
floor. Attach the cladding pipe and lock it in place against
the rear connection using the ring.
This creates a gap by the floor, which you conceal with
the enclosed wide ring.
Cladding pipe for support leg (accessory)
NVI 2000 - REAR CONNECTION