19
139775_R
03
GI 535 DV IPI June 2016
7.5 Final Positioning
1. Clean the Fireplace.
Use a vacuum to thoroughly clean all debris from the
firebox. This will eliminate the potential for the insert
fans to blow dust and debris back into the room.
2. Blower Power Cord:
Extend the blower power cord out forward of the
fireplace, routing it to the nearest power source.
The cord can extend approximately 8 feet (244 cm) to
the right or 4 feet (122 cm) to the left. A compatible
10 foot extension cord is available from your dealer,
Jøtul PN 223253.
3. Backer Plate Options:
Follow the procedures for installation of the various
backer plates detailed on pages 23-24.
RETAINER RAIL
RETAINER RAIL
7.6 Install Optional Brick Panels
! CAUTION !
THE PANELS ARE VERY FRAGILE. HANDLE GINGERLY,
BEING CAREFUL TO AVOID CHIPPING THE EDGES OR
CORNERS BY CONTACT WITH OTHER PARTS OF THE
FIREPLACE.
Tools Required
Flat Head Screwdriver
Pliers
Safety Glasses
157877 Traditional Red
• Rear Panel - 225723
• Left Side Panel - 225724
• Right Side Panel - 225721
157878 Brownstone
• Rear Panel - 225893
• Left Side Panel - 225891
• Right Side Panel - 225892
1.
Position each Panel Support Shelf (Fig. 7.10, A) on the
firebox floor against the side walls.
Use pliers to bend the Rear Panel support tabs (B)
down, perpendicular to the rear wall.
2.
Install the Rear Panel (C) up against the back wall,
resting on the support tabs. Fig. 7.11.
3. Slide each Side Panel (D) into position flat against the
firebox side, resting the bottom edge on the support
shelf. Fig. 7.12.
Locate the panel retainer tab at the top of the firebox
(E) and use the screwdriver to bend it down just enough
to secure the panel in place.
Fig. 7.12
Fig. 7.11
Fig. 7.10
