Jøtul FS 381, Installation Instructions With Technical Data

Page: 13 / 24

13
4.3 The surround consists of the following
parts (fig. 2):
Part Designation Quantity
1 Leg console 1 stk.
2 Threaded bar M8 x 70 4
3 Sleeve nut M8 x 15 8
4 Screw hexagon w/flange M8 4
5 Cassette 2
6 Side plate wright 1
7 Side plate left 1
8 Top plate 1
9 Nut hexagon w/flange M8 8
10 Front plate 1
11 Ash lip 1
12 Top grid 1
13 Bowl 1
Installation using top outlet
The product is supplied from the factory with the smoke outlet
fitted for the top outlet.
Thread the flue pipe (optional extra) through the top plate •
grate and place it in the smoke outlet.
Make sure that the gasket is properly seated between the flue •
pipe and the smoke outlet.
Fit the connection in the flue pipe. •
See measures under ”3.6 Steel chimney”.
NB: It is important for the joints/flue pipes to be sealed completely.
Air leaks may stop them functioning.
Installation using a rear outlet
Rear outlet can be installed.
Attaching the leg console on the burn chamber
1. Screw two nuts on each of the four threaded bars. See fig. 4 .
2. Fasten the threaded bars to the burn chamber and tighten
(fig. 4) .
3. Attach the leg console to the burn chamber with four nuts
(fig. 5) .
4. Stand the burn chamber up. Make sure you have assistance.
NB! Protect the floor because of sharp edges.
5. Attach the side cassettes. See fig. 6.
6. Make sure that the fireplace is level.
Attaching the steel surrounding set
1. Hook the two side plates together, (fig. 7).
2. Bend the flap on the inside a little upwards (fig. 8) .
3. Lift the side plates in position (fig. 9) and fasten them with
nuts (fig. 10) .
4. Place the top (fig. 11) and fasten it with nuts (fig. 12) .
5. Place both of the front panels into the slots and press down
(fig. 13).
6. Put the ash lip into place (fig. 14) .
5.0 Installation completed
See the General Use and Maintenance Manual for information
on how to use and look after the product.
5.1 Cleaning
The product can be cleaned with light diluted washing-up liquid
(preferably citrus). Then wash it off with clean water and dry well
with a clean and dry rag.
6.0 Optional extras
6.1 Floor plate in steel in front of the product
Steel, black paint: Cat. no. 351158
6.2 Floor plate in glas in front of the product
Cat. no. 351121
6.3 Outside air connection Ø100
Cat.no. 341296
eNglish