1
ENGlISh
Wood consumption
Jøtul C
150
FL
has a nominal heat output of
6,0
kW. Use of
wood, with nominal heat emission: Approx.
2,1 kg/h
. Another
important factor for proper fuel consumption is that the
logs are the correct size. The size of the logs should be:
Kindling:
Length: 20 - 40 cm
Diameter: 2 - 5 cm
Amount per fire: 6 - 8 pieces
Firewood (split logs):
Length: 30 cm
Diameter: Approx. 8 cm
Intervals for adding wood: Approximately every 45 -50 minutes
Size of the fire: 1,7 kg
Amount per load: 2 pieces
Nominal heat emission is achieved when the air wash vent is
open approximately 50%.
3.0 Installation
Jøtul C
150
FL is assembled as a cassette to fit into brick fireplaces
according to laws and regulations.
3.1 Floor
Foundations
It must be ensured that the foundations are dimensioned for
the fireplace. Cf.
«2.0 Technical data»
for specification of weight.
It is recommended that flooring which is not fastened to the
foundations – so-called floating flooring – is removed during
installation.
Requirement for protecting combustible
flooring in front of fireplace
The front plate must be in accordance with national laws and
regulations.
Contact your local building authorities regarding restrictions and
installation requirements.
3.2 Air supply
There must be space for heat expansion of the cassette between
the cassette and the brickwork. It would be an advantage to have
several vents in the brickwork, in order to improve heat emission
into the room.
Using a fireplace requires a plentiful supply of fresh air to the room
where the fireplace is installed. If the house is sealed, the room
must be equipped with additional fresh air supply through vents.
3.3 Chimney
The fireplace can be connected to a chimney and flue
pipe approved for solid fuel fired fireplaces with flue gas
temperatures specified in
«2.0 Technical data»
.
The chimney’s cross-section must be at least as big as the
flue pipe’s cross-section. See
«2.0 Technical data»
when
calculating the correct chimney cross-section.
Several solid fuel fired fireplaces can be connected to the
same chimney if the chimney’s cross-section is sufficient.
Connection to the chimney must be carried out in accordance
with the installation instructions from the supplier of the
chimney.
Before making a hole in the chimney the fireplace should be
test-mounted in order to correctly mark the position of the
fireplace and the hole in the chimney. See
fig. 1
for minimum
dimensions.
Ensure that the flue pipe is inclined all the way up to the
chimney.
Use a flue pipe bend with a sweeping hatch that allows it
to be swept.
Be aware of the fact that connections must have a certain
flexibility in order to prevent movement in the installation
leading to cracks.
N.B. A correct and sealed connection is very important for the
proper functioning of the product.
•
•
•
•
•
•
•
