GOJOTTO.COM
877-455-6886
PRODUCT CUSTOMIZATION:
(continued from page 5)
7.) Complete the customization with Rear Tray adjustments. Once
again turn the A-MOD Desktop over and now loosen (but do not
remove) the Rear Tray Adjustment Screws on the bottom panel
indicated in the image below. Slide the Rear Tray inward until the
rear tabs touch the laptop. Re-tighten the Rear Tray Adjustment
Screws. NOTE: If your laptop is deeper than you can adjust for, swap
out the Rear Tabs for the Offset Rear Tabs from the hardware bag.
8.) Make any adjustments needed to the Rear Tabs to allow access
to any data ports which may have been blocked by the original
clamp positions. Loosen the Rear Tab screws (but do not remove)
as shown in the image below. Adjust the Rear Tab as needed by
sliding side to side in the adjustment tracks. Re-tighten Rear Tab
Adjustment Screws.
9.) Ensure that your laptop is properly secured on the A-MOD
Desktop. Check that all screws have been tightened and all Tabs
and Clamps are fi rmly touching your laptop so that there is no
movement possible.
6
