PRODUCT CUSTOMIZATION:
Follow the steps below to achieve a
secure fi t for your laptop.
1.) Please check to make sure your laptop is
powered down, closed and all external devices,
including cables/cords have been removed.
2.) Begin by turning the A-MOD Desktop over and loosen
(but do not remove) the (4) Side Tray Adjustment Screws,
which are located on the bottom tray as shown in the image
below. Pull both Side Trays outward as far as they will go and
turn the Desktop back over with the silver side facing up.
3.) Place the open laptop onto the A-MOD Desktop and
position it as follows: slide the front edge forward so that it is
touching the Front Tabs and center the laptop from left to right.
NOTE: During this initial setup, you
may need to slide the open laptop
under the Side Clamps by angling
the front edge of the laptop under
the Side Clamps while entering
from the back of the unit and then
sliding forward until stopping on
the Front Tabs.
3
NEED SOME HELP?
Scan This QR Code To Watch A
Tutorial Video of These Steps.
