5
PRODUCT CUSTOMIZATION:
(continued from page 4)
5.) Carefully turn A-MOD Desktop and laptop over and re-tighten
the (4) Side Tray Adjustment Screws on the bottom tray. Return the
Desktop its’ upright position.
6. Now it is time to make any adjustments needed to the Side
Clamps to account for laptop height differences or to allow access to
any data ports which may have been blocked by the original clamp
positions. One side at a time, loosen the Side Clamp Adjustment
screws (but do not remove) as shown in the image below. Adjust
the Side Clamps as needed by sliding side to side and/or up
and down in the adjustment tracks. All Side Clamps should be
pushed as low as possible and touch the top edge of the laptop.
NOTE: If, after lowering all the way, the Side Clamps on your A-MOD
Desktop do not touch the top of your laptop, you can request an
alternate set of Side Clamps from Customer Service at 877-455-
6886. Once received, use steps 4.1 and 4.2 on page 4 to install your
new Side Clamps. If the Side Clamps already fi t properly, re-tighten
Side Clamp Adjustment Screws.
