5
Upper Handle
Adjustable Handle
Handle Spacer
Flat Washer Ø16
Hex Bolt
M6x45
Gauge & Lever Assembly
Pivot & Bracket Assembly
Nylon Lock Nut M6
Nylon Lock Nut M6
Handle
Control Rod A
b) Insert the upper end of
Control Rod A into the the
adjustable handle
STEP 3:
a) Insert bolts M6 x 45 through the upper left handle, then through the handle spacer and upper
handle on the right side, screw with flat washer Ø6 and lock nut M6. Slide gauge and lever assembly
onto the bolts and fasten with lock nut M6.
b) Tighten lock nuts securely.
STEP 4:
a) Push the adjustable handle to the lowest position.
b) Insert the upper end of the control rod into the hole at the end of the adjustable handle.
c) Take lower nut off the bottom end of the control rod and insert rod into the hole in the pivot and
bracket assembly.
d) Screw nut back into place.
a) Push this handle to the lowest position
c) Take off one ot the nuts and insert
the threaded pole into this hole
d) Then put on the nut again
3
4
