4
STEP 1:
a) Attach nylon washers and wheel to the right side of the axle then inserting a M5 x 45 bolt and
fastening with lock nut M5. Attach end cap by tapping with a wooden or rubber mallet.
b) Push another Wheel onto the axle. Insert nylon washers to the two sides of the wheel, then insert flat
washer Ø16 and attach end cap by tapping with a wooden or rubber mallet.
NOTE:
The nuts and bolts do not have to be completely tightened yet.
STEP 2:
Insert handle shaft between the top ends of the wheel assembly frames. Pass two bolts M6 x 45 through
wheel assembly frames and handle shaft. Slip pivot and bracket assembly onto protruding bolt ends.
Fasten with lock nuts M6. Pivot and bracket assembly should be on the right side of the handle when
standing behind the spreader.
GO BACK AND TIGHTEN ALL NUTS AND BOLTS ASSEMBLED SO FAR. DO NOT OVER TIGHTEN.
NOTE:
The handle can be higher or lower depending on the user’s preference. Before installing the
gauge, upper handles and handle shaft, decide which of the three positions will be most comfortable
for the operator. If the middle or upper positions are chosen, use a handle spacer in the hole nearest to
the handle grips.
End Cap
Nylon Washer
Wheel
Wheel Axle
Lock Nut M5
Hopper Assembly
End Cap
Flat Washer Ø16
Nylon Washer
Nylon Washer
Hex Bolt
M5x45
Hex Bolt M6x45
Pivot & Bracket Assembly
Nylon Lock Nut M6
Wheel Assembly Frame
Note: after assembling the handle, tighten the
nut on wheel assembly frame
Handle
Nylon Washer
Assembly Instructions
1
2
Hopper