(3) Prospector 100 PSI Carpet Extractor
2.0 Grounding Instructions Continued
WARNING:
Improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to whether the outlet is properly grounded. DO NOT modify the plug
provided with the equipment. If it will not fit into the outlet, have a proper outlet installed by a qualified electrician.
NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code.
3.0 Set-Up / Prepare Unit for Use
DO NOT USE ON WET SURFACES. DO NOT EXPOSE TO RAIN. STORE INDOORS.
• All Prospector Carpet Extractors, no matter what the time of year, are shipped with antifreeze in the solution lines.
Prior to first use, fill the tank with one gallon of warm water. Attach the hose and using the hand tool wand, flush out
the system by spraying the one gallon of water through the pump.
• Fill the solution tank with warm water (less than 100 degrees Fahrenheit). Fill to approximately 4 inches from the top.
Use a liquid detergent made for carpet cleaning or upholstery. Read and mix to the dilution ratios as directed.
• Do not use citrus acid, buterol or harsh degreasers inside the machine.
3.1 Power Priming the Solution Pump
Once water is in the solution tank, the solution pump must be primed:
• Connect the short prime hose that was included with your
machine to the solution outlet quick connect and place the
open end of priming hose inside the vacuum hose barb.
• Turn ON both vacuums then the solution pump. The
vacuum will pull solution through the pump into the
vacuum tank.
• Cup a hand around the hose and barb to increase the
vacuum suction on the hose. When the pump is primed,
you will hear the pulsation of the pump change.
• After priming, turn OFF the solution pump. Disconnect the
prime hose and connect your solution hose and tool.
If the pump still does not prime or if flow is low or unsteady,
check the hose from the solution tank to the pump (as well as
the filter) for clogging, kinks or restrictions. Clean or replace hose and/or filter and repeat the priming process.
If you are having trouble with the pump, refer to the “Trouble Shooting Guide” section or contact the Jon-Don technical
support team for advice or assistance.
3.2 Electrical
Plug cord(s) into 20 AMP grounded wall outlet(s). 20 AMP circuits are normally found in kitchens and bathrooms. Never
remove ground prong from the plug. If a circuit breaker trips during operation, turn machine off, reset the breaker and
move the electrical cord to a different outlet and resume operation.
If moisture does enter the vacuum motors, contact your local Jon-Don service center. To prevent moisture from damaging
the vacuum motors during storage, empty the recovery tank and store with the lid open.
