Johnson Outdoors i-Pilot, Manual

Page: 12 / 19

i-Pilot rev 04/21
9
For i-Pilot 1.0 & 1.5 systems: The i-Pilot Controller contains an internal speaker which can be programmed to work in
two different audio modes. The speaker is programmed to operate in audio mode 1 from the factory. To enable different
audio modes the hold “
+
” button and the “
-
” button down at the same time for three seconds.
For an explanation of each audio mode and their sounds see the table below:
WHAT CONDITION CAUSES IT
AUDIO
MODE
AUDIO PATTERN
Start up
Modes 1 and
2
4 short beeps
Manual prop on Mode 2 single beep
Manual prop off Mode 2 double beep
Speed + (when less than max speed) Mode 2 single beep
Speed - (when greater than speed 0) Mode 2 single beep
High speed bypass enable Mode 2 single beep
High speed bypass disable Mode 2 double beep
Button press for any of these (enable or disable): REC,
Pause, Track to Start, Track to End, AutoPilot, Cruise
Control, Spot-Lock, Spot-Lock Recall
Mode 2 single beep
Moving more than a quarter mile from the last track point
while in Record Pause mode
Mode 2 error
When GPS signal strength goes to no bars while in a GPS-
based mode
Mode 2 error
Attempting to enable a GPS feature when no signal strength
bars are shown
Mode 2 error
Attempting to replay a Track or recall a Spot-Lock location
when the boat is beyond the minimum distance
Mode 2 error
MOM button on the footpedal is pressed and a remote
button press attempts to override it
Mode 2 error
End of track attained during track playback (in conjunction
with canceling mode and turning the prop off)
Mode 2
high-low, high-low,
high-low
Switch to audio Mode 1
Modes 1 and
2
single beep
Switch to audio Mode 2
Modes 1 and
2
double beep
Learn button is pressed
Modes 1 and
2
steady tone
Learn successfully completed
Modes 1 and
2
4 longer beeps
©Johnson Outdoors 2021