e. Align the Outer Plate with the Base Extrusion.
Position the Outer Plate so that the widest portion is
facing inboard.
f. Use six ¼” x 1½” Stainless Steel Screws (Item
#12), six Flat Washers (Item #14) and six Nylock
Nuts (Item #20) to fasten the Outer Plate to the
bottom of the base extrusion. The Screws should
pass from the bottom of the Outer Plate and then
through the Base Extrusion. Place a Flat Washer on
the end of each bolt and then secure each Screw
with a Nylock Nut.
g. Re-install both side covers. Secure the Screws using a
#3 Phillips Screwdriver.
Motor Base
Motor Base
Extrusion
Extrusion
Outer
Outer
Plate
Plate
Nylock
Nylock
Nut
Nut
Flat
Flat
Washer
Washer
Inboard
Inboard
Outboard
Outboard
Stainless
Stainless
Steel Screw
Steel Screw
3f
3g
ITEM(S) NEEDED
#14 x 6
#20 x 6
#12 x 6
3
5 | minnkotamotors.com
©2021 Johnson Outdoors Marine Electronics, Inc.
