Series II Installation Manual Addendum
6
www.johnsoncontrols.com
LIT-12012316
Effective
May
2017
LED Status Indication
The status LED of the drive shows the status of the drive. The status LED is located in the
control panel, below the keypad, and it can show 5 different statuses
.
Color of the LED light
Status of the drive
Blinking slowly
Ready
Green
Run
Red
Fault
Orange
Alarm
Blinking fast
Downloading software
Control Board Terminals
Here is the basic description of the terminals of the standard I/O board.
Control Wiring
All control I/O wiring must be segre-
gated from line (mains) and motor ca-
bling
Control wiring shall be shielded twist-
ed pairs. To meet EMC levels required
by ENG1800-3 (2004). Control wiring
must be Type 4 cable
Run 120 Vac and +24 Vdc control I/O
in separate conduit
Control I/O terminals must be tight-
ened to 4.5 lb (0.5 Nm)
