TE-700 Series Sensor connected to a
VMA Controller
To replace a TE-700 Series Sensor with a TE-730
Series Sensor, follow the instructions in
To reuse a TE-700 Series Sensor connected to a
VMA controller, follow the instructions in
Replacing a TE-700 Series sensor
Replace a TE-700 Series Sensor with a TE-730 Series
Sensor. No cable adapters are required for this
scenario.
Note:
Refer to the
TE-730 Series Sensor
Installation Instructions (Part No. 24-10674-0)
to
install the TE-730 Series Sensor.
Reusing a TE-700 Series sensor
See the instructions in this section to reuse a
TE-700 Series Sensor when connected to a VMA18
controller.
1. Disconnect the 8-pin male jack plugged into the
VMA controller.
2. Plug the 8-pin male jack on the Y adapter
(Figure 10) provided with the VMA controller
into the 8-pin female socket labeled TSTAT on
the VMA18 controller.
3. Plug the 8-pin male jack that was plugged into
the VMA controller into the 8-pin female socket
of the Y adapter.
Note:
The 6-pin connection is not used
for this scenario and it should remain
unconnected.
4. Refer to the
TE-730 Series Sensor Installation
Instructions (Part No. 24-10674-0)
to install the
TE-730 Series Sensor.
Figure 12: Y Adapter at Controller Location
VMA1826/1832 VAV Controller Installation Guide
16
