Table 1: FX-PCV Controller physical features
Number
Feature
14
Device Address DIP Switch Block
15
Universal Input can be defined as:
Voltage Analog Input (0-10 VDC)
• Resistive Analog Inputs (0-600k ohm)
• 0-2K Potentiometer
• RTD: 1k Nickle 1k Platinum or A99B SI
• NTC: 10k Type L 10k JCI Type II, or 2.252k Type II
Dry Contact Binary Input
Wiring
CAUTION
Risk of Electric Shock
Disconnect the power supply before making electrical connections to avoid electric shock.
CAUTION
Mise En Garde: Risque de décharge électrique
Débrancher l'alimentation avant de réaliser tout raccordement électrique afin d'éviter tout risque de
décharge électrique.
Important:
Do not connect supply power to the controller before finishing wiring and
checking all wiring connections. Short circuits or improperly connected wires can result in
damage to the controller and void any warranty.
Important:
Do not exceed the controller electrical ratings. Exceeding controller electrical
ratings can result in permanent damage to the controller and void any warranty.
Important:
Use copper conductors only. Make all wiring in accordance with local, national,
and regional regulations.
Important:
Electrostatic discharge can damage controller components. Use proper
electrostatic discharge precautions during installation, setup, and servicing to avoid damaging
the controller.
For detailed information on configuring and wiring an MS/TP Bus, FC bus, or SA bus, refer to the
FX-
PC Series Controllers MS/TP Communications Bus Technical Bulletin (LIT-12011670)
.
FX-PCV terminals and bus ports
See Figure 2 for input and output terminal and bus port locations on the FX-PCV controller. Observe
the following guidelines when wiring an FX-PCV controller.
5
FX-PCV Programmable Variable Air Volume Box Controllers Installation Instructions