FX-BTCVT Bluetooth® Commissioning Converter Installation Instructions
4
Mounting
Location Considerations
Observe the following guidelines when mounting a
Bluetooth Commissioning Converter:
•
Always hang the Bluetooth Commissioning
Converter using the strap provided.
Note:
Use the strap loop to hang the Bluetooth
Commissioning Converter or attach the strap magnet
to a metal object (such as a metal pipe).
•
Mount the Bluetooth Commissioning Converter in
areas free of corrosive vapors and observe the
environmental limitations listed in the
Technical
Specifications
section of this document.
•
Objects (including ductwork, cabinets, doors, and
glass) can impede the wireless signal. Minimize
the number of objects between the laptop
computer and the Bluetooth Commissioning
Converter. Use line-of-sight, if possible.
Wiring
Wiring Consideration and Guidelines
Observe the following guidelines when wiring the
Bluetooth Commissioning Converter:
•
Do not allow the Bluetooth Commissioning
Converter to hang from the cable connection.
•
Provide some slack in the cable between the
Bluetooth Commissioning Converter and the
controller.
Hard-Wired System Configurations
Figure 2 and Figure 3 show the Bluetooth
Commissioning Converter in common hard-wired
system configurations.
Note:
When the Bluetooth Commissioning Converter
is connected at any of the points shown in Figure 2 and
Figure 3, you can commission any FX-PC controller on
the trunk regardless of whether it is connected directly
to the FC Bus or through the FX-ZFR Wireless Field
Bus System.
Figure 2: Converter Connected to FX-PCG
FI
G
:FX
-P
CX
_
P
CG
Sensor
Port
FX-BTCVT
FX-PCX
SA Bus
FX-PCG
PCG
Figure 3: Converter Connected to SA Bus Device
FX-PCV
FI
G
:FX
-P
C
V
_Co
nne
ct
Sensor
Port
FX-BTCVT
Network
Sensor
FX-PCV-1610-0
