5. Sending Commands from Controller
The operation commands are sent by
pressing each button facing the transmitter
of the controller toward the receiver of the
receiver kit.
1. When the commands are sent, the
indication “
” on the LCD of the
controller flashes once.
2. When the receiver kit receives the
commands, the indication light (yellow)
on the receiver kit turns ON for an
instant, and the buzzer sounds.
ATTENTION:
* The capable distance for transmitting using the wireless remote controller is maximum 20 feet (6
meters). (The distance may differ depending on the type of a receiver. Check the receiver kit, or
refer to the Operation Manual supplied with the indoor unit.) The distance will get shorter if the
angle of transmission is not vertical to the receiver or an electronic type light is used in the room.
Liquid Crystal Display (LCD) Indication
When viewed from certain angles, the LCD can be difficult to read.
The viewing angle will range from an optimal angle of 60° down to
30°, as shown in the diagram at right. If the viewing angle is below
30°, those readings not displayed appear slightly faded so that it
makes for a difficult read. It is a mechanical fault with of this LCD,
which is not considered an irregularity.
60
o
30
o
4. Installation Method
When installing the wireless controller onto a wall or a pillar, fix firmly the holding bracket onto the wall and
attach the controller where the receiver can receive the commands.
ATTENTION:
Maintain a distance more than 12 inches (31 cm) away from power cables.
Screws
Holding Bracket
Receiver Kit
Capable Distance
for Transmitting:
Max. 19.7ft. (6m)*
CIR01
Receiver
Indication Lamp (Yellow)
turns ON for an instant.
(Green) (Yellow) (Green) (Red)
EMERGENCY
COOL
HEAT
RUN
FILTER DEF
TIMER
7
P5415475
