To mount the display in a remote control panel or
gypsum plaster wall:
1. Avoid locations such as the heat exchanger,
variable frequency drive (VFD), or any housing
that may contain electric motors or other
strong sources of electrical interference.
Mount the display enclosure on a vibration
free surface.
2. Make an appropriate cutout in the panel using
the dimensions shown in Figure 3. Note the
maximum display thickness shown in the
After the display is securely mounted in its location:
1. Connect the serial communications cable,
Ethernet cable for MAP, and power supply to
the display. Use one of the removable slots
provided on the box to run cable back to the
controller.
Note:
Refer to the sections
a display with a single controller
and
Cabling a display with multiple
terminations.
2. Ground the display unit.
3. Ensure the aeration holes located on the side
of the display are not covered.
4. Place the display in the bracket, apply slight
pressure on the front of the display. Make
sure to push the display in all the way so that
it is firmly secured in place
Figure 9: Remote panel/gypsum plaster wall-mounting the display
Cutout
X
Y
BOX710-01
10.90 (277)
7.55 (192)
Note:
Dimension in inches (mm).
Advanced Graphic Touchscreen Display on 25 Ton to 80 Ton Johnson Controls Premier Rooftop Units
13
Johnson Controls
