Johnny Vac JVC70RIDER, Operator'S Manual

Page: 10 / 40

10 www.johnnyvac.com
Parts need to be cleaned up: A
solution tank, brush, pad holder
or pad, a squeegee assembly, a
vacuum motor and a recovery
tank.
Brushing function is controlled
by the buttons on the control
panel. Turn on brush motor
switch and squeegee lifting
switch, lay the brush and
squeegee down. Set forward/
backward switch to "forward"
position, adjust the speed switch
appropriately (turn the switch to proper speed and water yield based on different
types of ground). Release the manual brake and depress the pedal to start washing.
There are two brushes available, and the width of brush head is 360mm (14 inches).
NOTE: The type of brush head or cleaning pad is determined by the severity and
type of dirt. For special suggestions, please refer to Section Brush Information of
this manual or conduct the representatives of GAOMEI.
Scrubbing Method
Water and detergent in solution tank flow to the brush and ground via the magnetic
valve. The solution of water and detergent is used to scrub the ground by brush head
rotation. The squeegee will take up the waste water into solution tank with vacuum
motor while the machine is operating.
Operation Principle