8
Johnny Vac V1 (14-10)
OPERATION PRINCIPLE
The machine's washing unit consists of: recovery tank, solution tank,
brush, pad holder or cleaning pad, squeegee assembly, and a set of
suction motor and driving motor.
The buttons, on the control panel, controls brushing function. Turn on
brush motor switch and squeegee lifting switch, lay the brush and
squeegee down. Set forward/backward switch to "forward" position;
adjust the speed switch appropriately (turn the switch to proper speed
and water yield based on different types of ground). Release the manual
brake and depress the pedal to start washing.
The width of the machine’s brush head is 405 mm (15”).
NOTE
: The type of brush head or cleaning pad is determined by the severity and type of dirt. For special
suggestions, please refer to Section Brush Information of this manual or consult the representatives of
JOHNNY VAC.
Scrubbing Method
Water and detergent in solution tank flow to the brush, then ground, via the magnetic valve. The solution of
water and detergent is used to scrub the ground by brush head rotation. The squeegee will take up the
wastewater into recovery tank with vacuum motor while the machine is operating.
BRUSH INFORMATION
Please use an appropriate type of brush so as to guarantee an optimal effect. Recommended brush and
cleaning pad are given as follows:
•
Nylon brush - suitable for floor tile cleaning without scratches.
•
Pad holder and cleaning pad - suitable for floorboard or painted ground to generate brightness.
JVC110RIDER
Pad holder and cleaning pad mold: 405 mm (15”) - MALISH
Brush mold: 405 mm (15”) - MALISH