– 16 –
Installation Checklist
IV) OPERATION
Startup
DO NOT ATTEMPT TO START BURNER IF ANY OF THE
FOLLOWING CONDITIONS EXIST:
1. Excess oil has accumulated.
2. The unit is full of vapours.
NOTE:
Refer to the instruction manual supplied with the
burner for installation, start up and adjustment.
After the installation is finished and the installation checklist
completed, proceed as follows:
1. Set the draft regulator for full draft.
2. Turn on oil at the tank. Adjust the air band on the burn-
er according to the instructions provided by the burner
manufacturer.
3. Close the inspection cover on the burner mounting
panel, and press the reset button on the combustion
safety control.
4. Set electric switch to “ON” position. The burner should
start.
5. Make the air adjustment and take the necessary com-
bustion test readings as specified by the burner manu-
facturer.
Water Temperature Regulation
Once installed, the operation will be completely automatic.
The thermostat (aquastat) on the water heater is adjustable
and will maintain water at the desired temperature.
Thermostats are factory set at 49°C (120°F). Contact a qual-
ified Oil-Burner Technician for adjustment. Set the tank ther-
mostat as low as possible to provide an adequate supply of
hot water. This will conserve oil and extend the life of the
tank.
Check Here
1.
Have the safety precautions described in the
manual been implemented?
2.
Does the oil piping conform to the recommen-
dations of your Oil Supply Company?
3.
Has the oil piping been tested for leaks?
4.
Is the clearance between the water heater and
combustible construction as per specifica-
tions?
5.
Is the water piping correctly connected? Are
you certain that there are no leaks?
6.
Is the water heater filled with water?
7.
Is the cold water supply valve open?
8.
Is the flue pipe installed properly and are the
vertical and horizontal runs properly support-
ed?
9.
Is the draft regulator intake opening unob-
structed?
10.
Is the T&P valve installed? Are the drain pipe (if
installed) and T&P valve unobstructed?
11.
Is a drain pan installed (if required) with a
proper overflow pipe, directed to a drain?
12.
Have you taken steps to prevent water damage
in case of leaks?
13.
Does the area around the water heater have
adequate ventilation?
14.
Air moving device does not create negative
pressure?
15.
Flammable vapours and materials are not
placed in the proximity of the water heater?
If the answer to all the above is “Yes”, proceed with the
“Startup” instructions.
CAUTION:
Read before proceeding. If you do not follow
these instructions exactly, a fire or explosion
may result, causing property damage, per-
sonal injury or loss of life.
WARNING:
Risk of scalding
Hot water can produce third degree burns
in 6 seconds at . . . . . . . .60°C (140°F)
in 30 seconds at . . . . . . .54°C (130°F)
in 5 minutes at . . . . . . . . .49°C (120°F)
