Thank you for purchasing this Roman Blind. Please read the instructions carefully before use
to ensure safe and satisfactory operation of this product. It is recommended that
this blind should only be installed by persons competent in DIY.
Warnings!
Please read all safety warnings and installation information fully before installation.
Young children can be strangled by loops in pull cords, chains, tapes and inner cords
that operate the product.
To avoid strangulation and entanglement, keep cords out of the reach of young children.
Cords may become wrapped around a child’s neck.
Move beds, cots and furniture away from window covering cords.
Do not tie cords together. Make sure cords do not twist and create a loop.
The safety clips should be positioned high enough to be out of reach of small children
yet accessible to adults.
All safety clips for blinds need to be
fi
xed to a solid surface using a screw and
fi
xing suitable
for the wall or surface material. These items should not be glued or stuck in place.
The head rail shall not be installed less than 1.5m from the
fl
oor.
For further information go to: www.makeitsafe.org.uk
Keep out of the reach of young children.
Small parts - choking hazard.
Parts list
Please check the contents
:
Mounting brackets 2 x <110cm , 3 x >110cm
Screws and Wall Plugs
5
x <110cm ,
7
x >110cm
1 Safety clip
<
90
cm: 2 x
>
120
cm: 3 x
<
90
cm:
5
x
> 1
20
cm:
7
x
1
x
Please note:
Additional fasteners other than those sent with your blind may be required depending
on the mounting surface. Wallboard and plaster require the use of anchors such as expansion or toggle
bolts. Brick, tile or stone need special plugs and drill bits. Remember to always pre-drill holes in wood
to avoid splitting.
1. Positioning the blind
A
Inside the recess
Decide on the position of the blind so that it will be clear of any latches and fixtures.
B Outside the recess
Decide on the position of the blind so that it overlaps on both sides equally. At least
5cm.
(
a
)
(
b
)
Assembly
2.
Fixing the brackets
A.
Please ensure that the headrail is installed 1.5meters from the
fl
oor.
B.
The brackets are designed for face or top fixing to the window frame,
wall, or ceiling.
C.
Attach the brackets to the headrail by inserting into the
channel on the reverse.
D.
Having decided the positioning of the blind, present it to the desired
position, making sure it is centred and level.
E.
Mark the location of each bracket with a pencil.
F.
Remove each bracket from the headrail by pressing the locking
tab at the bottom of the bracket.
G.
Place each bracket on its location markings and mark through
the desired screw hole positions.
H.
Use the screws provided to fix the brackets to wood. For masonry ,
use
appropriate fixings.
2
3
T
op fix
F
ace fix
(
e
)
