Problem
Possible solution
You cannot set an option.
• Make sure that you press only the desired button(s).
The appliance does not dry or
does not dry correctly.
• Turn the water tap on.
• Make sure the drain filter is not clogged.
• Reduce the laundry load.
• Make sure you have set the correct cycle. If necessary, set the dryer for a
short time again.
The laundry is covered with
fluff.
The fabrics washed in the previous cycle released fluff of a different colour:
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the special programme
to clean it (refer to “How to remove fluff" for more details).
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes, deactivate and activate the appliance. If the problem continues, contact
the Authorised Service Centre.
Emergency door opening
In case of power failure or functioning failure the
appliance door remains locked. The washing
programme continues when the power is
restored. If the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
Caution! Make sure that the
water temperature is not too
high and the laundry is not
hot. If necessary, wait until
they cool down.
Caution! Make sure that the
drum is not rotating. If
necessary, wait until the drum
stops rotating.
Make sure that the water
level inside the drum is not
too high. If necessary,
proceed with an emergency
drain (refer to «Emergency
drain» in «Care and cleaning»
chapter).
To open the door, proceed as follows:
1. Press the On/Off button to switch the
appliance off.
2. Disconnect the mains plug from the mains
socket.
3. Open the filter flap.
4. Keep the emergency unlock trigger pulled
downward and, at the same time, open the
appliance door.
Washer Dryer User Manual
40
