4. When
flashes, turn the knob for the
temperature to set the pyrolysis duration:
Option
Description
P1
Light cleaning. Du-
ration: 1 h 30 min.
P2
Normal cleaning.
Duration: 3 h.
After 2 seconds the pyrolysis starts.
You can use the END function to delay the start
of the cleaning.
During the pyrolysis the oven lamp is off.
5. To change the default length of the pyrolysis
(
P1
or
P2
), press
to set
, and then turn
the knob for the temperature.
6. When the oven is at the set temperature, the
door locks. The display shows
and the bars
of the heat indicator until the door unlocks.
7. When pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
8. When the oven is cool again, a signal sounds
and the door unlocks.
Cleaning reminder
To remind you that the pyrolysis is necessary,
PYR flashes in the display for 10 seconds after
each activation and deactivation of the oven.
The cleaning reminder goes
out:
• after the end of the pyrolysis.
• if you press
and
at the
same time while PYR flashes in
the display.
Removing and installing the
door
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
Warning! Be careful when you
remove the door from the
appliance. The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on the two
door hinges.
A
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each side and
pull it away from the appliance at an upwards
angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to prevent
scratches.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
Oven User Manual
39
