Problem
Possible cause
Remedy
The display shows "C1".
The Pyrolysis does not operate.
You did not remove the shelf sup-
port / telescopic runners.
Remove the shelf support / tele-
scopic runners.
The display shows "C2".
You want to start the Pyrolysis or
Defrost function, but you did not
remove the core temperature sen-
sor plug from the socket.
Remove the core temperature sen-
sor plug from the socket.
The display shows "C3".
The cleaning function does not op-
erate. You did not fully close the
door, or the door lock is defective.
Fully close the door.
The display shows "F102".
• You did not fully close the door.
• The door lock is defective.
• Fully close the door.
• Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
• If the display shows "F102"
again, contact the Customer
Care Department.
The display shows an error code
that is not in this table.
There is an electrical fault.
• Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
The appliance is activated and does
not heat up. The fan does not oper-
ate. The display shows
"Demo"
.
The demo mode is activated.
1. Deactivate the oven.
2. Press and hold at the same
time
.
3. The first digit on the display
and
Demo
indicator start to
blink.
4. Enter the code 2468 by turning
the knob for the temperature
right or left to change the val-
ues and press
to confirm.
5. The next digit starts to blink.
6.
Demo
mode deactivates
when you confirm the last digit
and the code is correct.
Oven User Manual
42
