John Bean EHP System I, Operation Instructions Manual

Page: 14 / 28

- Page 14 -
1.6 GENERAL CAUTIONS
A. DURING THE USE AND MAINTENANCE OF THE MA-
CHINE IT IS MANDATORY TO COMPLY WITH ALL LAWS
AND REGULATIONS FOR ACCIDENT PREVENTION.
B. THE ELECTRICAL POWER SOURCE MUST HAVE A
GROUND CABLE AND THE GROUND CABLE OF THE
MACHINE MUST BE CONNECTED TO THE GROUND
CABLE OF THE POWER SOURCE.
C. BEFORE ANY MAINTENANCE OR REPAIRS ARE AC-
COMPLISHED THE MACHINE MUST BE DISCONNECTED
FROM THE AIR AND ELECTRICAL SUPPLY.
D. NEVER WEAR TIES, CHAINS OR OTHER LOOSE AR-
TICLES WHEN USING, MAINTAINING OR REPAIRING THE
MACHINE. LONG HAIR IS ALSO DANGEROUS AND
SHOULD BE KEPT UNDER A HAT. THE USER MUST
WEAR PROPER SAFETY ATTIRE - GLOVES, SAFETY
SHOES AND GLASSES.
2.0 INSTALLATION
Your new JBC EHP SeriesTire Changer requires a
simple installation procedure requiring only a few mo-
ments. Follow these instructions carefully to insure
proper and safe operation.
The Tire Changer is delivered mounted to a wooden
skid. Remove tire changer from its mounts carefully,
taking care to avoid any back strain.
Place Changer where proper operation will be unob-
structed to all sides. Install the machine in a covered
and dry place.
2.0.1 Models with SRA attached
Once placed in the desired location the tire changer
must be bolted to the floor using only the rear two mount-
ing holes. Mounting anchors are provided with those
machines with a Safety Restraint Arm.
Tire Changer must be anchored to concrete floor
if equipped with a “Safety Restraint Arm”
2.1 ELECTRICAL INSTALLATION
BUILDING ELECTRICAL INSTALLATION MUST BE
MADE BY A LICENSED ELECTRICIAN.
Check that the electrical specifications of the power
source are the same of the machine. The machine uses
110v, 60 hz, single phase 20 amp source. Electric
specifications are clearly marked on a label at the rear
of the machine.
FAILURE TO PROVIDE PROPER ELECTRICAL
SUPPLY AND GROUNDING WILL CREATE A
SHOCK HAZARD TO THE OPERATOR.
540
For Reference Only
For Current Info See Equiserv.com