Johansson proflex 5500, User Manual

Page: 12 / 21

5500 ProFlex
11
DEVICE CONFIGURATION
It is of utmost importance that your device is configured in a right way in order to make the
ProFlex installation successful. To do so, follow the below mentioned steps carefully.
1. Input
1.1 Define the LNB settings (INPUT > LNB > INPUT 1-4)
o
Input : Sequence number of the input (also indicated on the front
of the actual module)
o
Label : custom label for each input (e.g. VLow, or ASTRA
19.2VLow , …)
o
Voltage : The LNB voltage to select the polarization

13V: Vertical polarization

18V: Horizontal polarization
o
Tone : LNB tone to select low/high band

ON: high band

OFF: low band
o
DiSEqC ®: control of a DiSEqC® switch (A/B/C/D)
o
Band : Satellite band

Ku-band

C-band
o
Extended Voltage : Add 1V to the LNB voltage to compensate the
cable losses for long coaxial cables.
o
Enable : do not forget to enable the LNB input, this is disabled by
default)
o
Press APPLY to confirm the parameters.