Jobsite CT5559, Original Instruction

Page: 5 / 16

4
replacement parts. This will ensure that the safety of the power tool is
maintained.
6) Additional Information.
a) Wear ear protectors. Exposure to noise can cause hearing loss.
b) Always wear eye protection.
c) If the supply cord is damaged, it must be replaced by an authorized service
agent in order to avoid a hazard.
d) It is recommended that a residual current device of 30mA sensitivity or less is
used in the power supply system that this tool is to be plugged in to.
7)Safety instructions for all operations
a) Do not use accessories which are not specifically designed and recommended
by the tool manufacturer. Just because the accessory can be attached to your
power tool, it does not assure safe operation,
b) The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool. Accessories running faster than their rated
speed can break and fly apart.
c) The outside diameter and the thickness of your accessory must be within the
capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
d) Do not use a damaged accessory. Before each use inspect the accessory If
power tool or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and run the power tool
at maximum no-load speed for one minute. Damaged accessories will normally
break apart during this test time.
e) Wear personal protective equipment. Depending on application use face
shield safety goggles or safety glasses. As appropriate, wear dust mask hearing
protectors, gloves and workshop apron capable of stopping small abrasive or
workpiece fragments. The eye protection must be capable of stopping flying
debris generated by various operations. The dust mask or respirator must be
capable of filtrating particles generated by your operation. Prolonged exposure to
high intensity noise may cause hearing loss.
f) Keep bystanders a safe distance away from work area. Anyone entering the
work area must wear personal protective equipment. Fragments of workpiece or
of a broken accessory may fly away and cause injury beyond immediate area of
operation.
g) Hold power tool by insulated gripping surfaces only, when performing an
operation where the cutting accessory may contact hidden wiring or its own cord.
Cutting accessory contacting a “live” wire may make exposed metal parts of the
power tool “live” and shock the operator.
Note the above warning may be omitted if polishing is the only recommended
operation.
h) Position the cord clear of the spinning accessor If you lose control, the cord
may be cut or snagged and your hand or arm may be pulled into the spinning