10
Photo III
2. Tiller adjustment
2.1 Handle frame adjustment
Adjust the height and direction of handle frame by lock hands.
2.2 Tilling depth adjustment
Control the tilling depth by adjusting the height of the resistance rod. Rod going down,
tilling depth decreased; Rod going up, tilling depth increased.
3. Engine start and stop
3.1 Shift lever must be in the neutral gear position before starting the tiller.
3.2 Start the gasoline engine following the steps of user manual.
3.3 Engines should run in the low speed (1450-1750r/min) for 2-3 minutes without load.
3.4 Check if the engine runs normally, if abnormal, please turn it off and repair.
4. Operation
4.1 Starting tiller: Clutch bar should be disengaged, and all gear shifting levers should be
in neutral gear position, and then start the engine following the usual manual.
4.2 Running: Put gear shifting handle in the required gear position, clench the clutch
handlebar to make the tiller work/walk.
4.3 Parking:
a) Loosen Clutch handlebar;
b) Put Gear shifting lever to Neutral position;
△
! Attention
Don’t rotate dipstick, don’t add lube oil between upper level and lower level.
△
! Attention
Please put the tiller on firm land level before adjusting the handle height to
prevent the handle from collapsing accidentally.
△
! Attention
Shift lever must be in the neutral gear position.
△
! Attention
The tiller must running-in before starting using. Check Chapter VI for running-in
method.
