7
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book
carefully.
INTENDED USE
The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY (SEE FIG. A)
NOTE:
a) Do not use any charger other than that specifically provided
for use with the equipment.
b) If the battery pack is very hot you must remove your battery
pack from the charger and allow time for the battery to cool
down before recharging.
c) The battery in your new tool is not charged when it leaves
the plant. Therefore it must be full charged before using the
first time.
d) Please charge the battery to reach full or no less than half
charge before storage. If the tool will not be used for long
periods of time, charge the battery every 3-6 months.
Charging procedure
1) Plug the charger into an appropriate outlet. The light will
be green.
2) Slide the battery pack into the charger, the light will turn to
red to indicate the charging process has started.
3) When charging is completed, the light will turn to green.
The pack is now fully charged, unplug the charger and remove
the battery pack.
WARNING:
When battery charge runs out after
continuously use or exposure to direct sunlight or heat,
allow time for the tool to cool down before re-charging to
achieve the full charge.
Charging indicator
This charger is designed to detect some problems that can
arise with battery packs. Indicator lights indicate problems
(see table below). If this occurs, insert a new battery pack to
determine if the charger is OK. If the new battery charges
correctly, then the original pack is defective and should be
returned to a service center or recycling service center. If the
new battery pack displays the same problem as the original
Battery Pack, have the charger tested at an authorized
service center.
Light
Status
Red on
Charging
Green on
Fully charged
Fig.A
Fig.B1
Fig.B2
Fig.C
Fig.E
Fig.D2
Fig.D1
Fig.H
Fig.G
Fig.F
Summary of Contents for JMCDT218W
Page 1: ...SAFETY AND OPERATING MANUAL 18V DRILL DRIVER KIT JMCDT218W...
Page 5: ...5 1 2 3 4 5 9 8 7 6...
Page 12: ......
